Tomax 400W Magnetic Ballast

Price: L7,501.00lek

Code:

3615
Weight:

5.800 Kgs

Ballast With a Rated Power of 400 W. Appropriate for High Pressure Sodium and Metal Halide bulbs.

Quality Lighting Ballast

This ballast allows the stabilization of the current supplied in output at the same time guarantees a greater stability of the luminous flux and consequently a greater duration of the lamps. Closed body for further isolation and safety, It is wired easily thanks to the screw terminals on the front.

Suitable for the lighting of bulbs HPS and MH 400W.

Power: 400w
Works with both HPS and MH lamps
Voltage: 220-240V/50Hz
Easily mountable
Long strike distance to the lamp up to 15m
Thermal cutouts to protect against short circuits
Pre-wired input and output cable
CE certified
Fuse: Yes
18 Months Warranty

Quick Buy

Just 3 fields to fill in

We will contact you to finalize the order

600W ballast magnetic ballast

Send to friend

Rate this product

Safety

The product is designed for use with HID Lamps and HID reflectors.
Electricity can cause death, so always use a circuit breaker with this product.
Before doing anything with the unit, make sure the power supply is disconnected.
After switching on, allow the unit to discharge by leaving it plugged in for at least 3 minutes before switching off.
The unit and especially the lamp will get hot during use. If the lamp has been on, leave it to cool for at least 3 minutes before touching it, and never touch the lamp while it is switched on.
Never stack the unit on top of each other since the unit dissipates its heat through its casing.
Never switch on the unit without a lamp and reflectors plugged into it.
Make sure you use a lamp and reflector that is compatible with the unit.

Installation

Please make sure that the unit is on a stable, non-flammable surface and make sure that there is adequate ventilation around the unit. Also, make sure that any protective plastic covering on the reflector is removed before switching on the system.

Troubleshooting

If the system fails to operate, switch it off, wait for 30 minutes for the lamp to cool, and then unscrew the lamp and screw it back in firmly again. Switch the unit back on. If the lamp still fails, contact us.